In DtTenon, aumentato angolo limite per decidere se ribaltare trave

LuaLibs/ProcessDtTenon.lua

@@ -64,14 +64,14 @@ local function VerifyOrientation( Proc, vtN, b3Raw)
       -- se tenone praticamente in asse, accetto fino a -22 deg
       if abs( vtN:getY()) < 0.088 then
          return ( vtN:getZ() >= -0.375)
-      -- altrimenti, accetto fino a -10 deg
+      -- altrimenti, accetto fino a -12.5 deg
       else
-         return ( vtN:getZ() >= -0.174)
+         return ( vtN:getZ() >= -0.216)
       end
    -- altrimenti
    else
-      -- accetto fino a -7deg
-      return ( vtN:getZ() >= -0.122)
+      -- accetto fino a -12.5 deg
+      return ( vtN:getZ() >= -0.216)
    end
 end
 
@@ -209,7 +209,15 @@ function ProcessDtTenon.Make( Proc, nPhase, nRawId, nPartId, dOvmHead)
             local CutProc = { Id = AddId, Grp = Proc.Grp, Prc = Proc.Prc, Box = Proc.Box, Fct = Proc.Fct, Flg = Proc.Flg,
                               Head = Proc.Head, Tail = Proc.Tail, CutId = Proc.CutId, TaskId = Proc.TaskId, PartId = Proc.PartId}
             CutProc.AffectedFaces = BL.GetProcessAffectedFaces( CutProc)
-            local bFromBottom = ( b3Solid:getDimX() < BD.LEN_SHORT_PART and vtExtr:getZ() > 0.25)
+            
+            -- se esiste grezzo successivo non serve tagliare dal basso
+            local bFromBottom
+            local nNextRawId = EgtGetNextRawPart( nRawId)
+            if nNextRawId and EgtGetRawPartBBox( nNextRawId):getDimX() > BD.MinRaw and not Proc.Tail then
+               bFromBottom = false
+            else
+               bFromBottom = ( b3Solid:getDimX() < BD.LEN_SHORT_PART and vtExtr:getZ() > 0.25)
+            end
             local bOk, sErr = Cut.Make( CutProc, nPhase, nRawId, nPartId, dOvmHead, bFromBottom)
             if not bOk then return bOk, sErr end
          end

LuaLibs/ProcessLongDoubleCut.lua

@@ -1280,10 +1280,10 @@ function ProcessLong2Cut.Make( Proc, nPhase, nRawId, nPartId, bForcedBladeMaster
                nFin = 1
             else
                if vtN[vOrd[1]]:getZ() >= vtN[vOrd[2]]:getZ() then
-                  if vtN[vOrd[2]]:getZ() < dLimitAngle then
-                     nFin = 1
-                  else
+                  if vtN[vOrd[1]]:getZ() < dLimitAngle then
                      nIni = 2
+                  else
+                     nFin = 1
                   end
                else
                   if vtN[vOrd[1]]:getZ() < dLimitAngle then