Slicing Direction: Can be Vertical, Horizontal or 45°. This affect the orientation of the extrusion.
Spiral Vase: In this mode, the model’s outline will be printed with one single shell for each layer and a continous print, without stopping at the completion of each single slice.
Strand Height: Set the height of the slice.
Strand Width: Set the width of the slice.
Strand Count: Set the number of shells to be printed
Offset: Distance from the original solid surface, extra material that will be removed.
Strand Overlap: % of overlap between shells.
Start Point Offset On Layer: Distance from the start of a shell and the start of the contiguous one.
Strand Order: Set if the solid have to be print from outside to the inside or from the inside to the outside.
Direction: Direction of the strand deposition (can be clockwise or counterclockwise)
Floor Count: Number of filled layers at the base of the solid
G0 Feed: Feed used when the head is moving without extruding
Nozzle Diameter: Diameter expressed in millimiters of the nozzle.
Flow Rate: This determines how much material is extruded when printing. The default amount is set to 100%.
Print Parameters 