Icarus Documentation

Tabs

Link Type: Set the type of the shell link; can be Linear, None or Biarc.
Link Param: Length of the link between horizontal passes
Link Z Up: Distance traveled in Z by the extruder when it goes in rapid movement, millimeters
Lead In: Type of entrance of the strand in the solid. Can be None, Linear, Arc.
Lead In Tang Dist: Distance on the tangent direction from starting layer point to the entrance point.
Lead In Ortho Dist: Distance on the orthogonal direction from starting layer point to the entrance point.
Offset Lead Point: Distance from the start point of a slice to the end point of the same slice in mm. Used to avoid material overlap
Lead Out: Can be None: no lead towards the outside; Linear: linear exit; Arc: Arc exit.
Lead Out Tang Dist: Distance on the tangent axis from the exit point to the end layer point.
Coasting Lenght: Distance in millimeters before the end of the path where the nozzle is closed to stop the deposition of the material.
Coasting Feed: Speed of advancement expressed in millimeters / minute for the execution of the CoastingLen section
Wipe Lenght: Distance in millimeters of the extension of the passes with the nozzle closed to clean it of any excess material
Wipe Feed: Feed speed expressed in% with respect to the value of the Feed parameter. 0.89 indicates 89% of the value of the Feed
Wipe Direction: Direction expressed in degrees for the extruder during the wiping; for example, 0 is orthogonal to the direction of movement.